Parts of a Bong: An A-to-Z Glossary of Bong Terms

Cartoon diagram of mrb0ng the beaker bong with arrows labeling his mouthpiece, neck, bowl, downstem, chamber and water line

The basic parts of a bong are the mouthpiece, neck, chamber, downstem and bowl (also called a slide). Smoke goes from the bowl, down the downstem, bubbles through water in the chamber and comes up the neck to the mouthpiece. Below, mrb0ng explains each part, then translates the head-shop slang from A to Z.

b0ng.com sells Freeze Pipe products. This guide is for adults 21+ where cannabis is legal.

The Parts of a Bong, Top to Bottom

Look at the cover cartoon: that's me, and I'm a beaker. Most water pipes share the same layout, whatever their shape.

Mouthpiece
The open rim at the very top where your lips go. Make a gentle seal inside the rim, not over the outside like a trumpet.
Neck
The tube between the mouthpiece and the chamber. Smoke cools down a little more on its way up, and longer necks give it more time to do that.
Ice pinch (ice catcher)
Three or so little dents pressed into the neck. They hold ice cubes up off the water so the smoke passes through cold air before it gets to you.
Chamber
The main body of the bong that holds the water. A beaker has a cone-shaped base and a straight tube is a cylinder all the way down. Beaker vs. straight tube covers how they differ.
Water line
How full you fill it. The rule of thumb is to cover the slits at the bottom of the downstem by about an inch. Bong Water 101 covers the details.
Downstem
The slim tube that runs from the bowl down into the water. A "diffused" downstem has slits or holes at the tip, which break the smoke into smaller bubbles.
Bowl (slide)
The small cup where the dry herb goes. It's called a slide because on many bongs you lift it out to clear the chamber, which works like a carb.
Carb
A small hole you keep covered with your finger while you draw, then uncover to let in fresh air and pull the smoke through. Plenty of modern bongs don't have one and use the slide instead.
Joint
The ground-glass socket where the downstem or bowl plugs in. It has its own section below because it decides which accessories will fit.
Percolator (perc)
An extra chamber or insert inside the bong that splits the smoke into more bubbles, so it has more contact with the water. Tree, showerhead, honeycomb, matrix and inline percs are all variations on that idea. Percolators Explained goes through each type.

Joint Sizes and Genders, Explained

Cartoon chart of 10mm, 14mm and 18mm bong joints, with a frosted male joint fitting into a female joint, as mrb0ng says match the size and the gender
Match the size and the gender before you click "add to cart."

Bong joints borrow from lab glassware. Their frosted, ground-glass surfaces are tapered (lab standards use about a 1:10 taper) so the two pieces seal tightly without any rubber. The size number is roughly the outside diameter of the male piece in millimeters.

  • 10mm: small and mostly found on mini rigs.
  • 14mm: the most common size on bongs and rigs today, with the widest choice of bowls and ash catchers.
  • 18mm: wider and common on bigger bongs and older-style glass.

Male joints are frosted on the outside and slide in. Female joints are frosted on the inside and take a male piece. A 14mm female bong needs a 14mm male bowl, so match both the number and the gender. If your pieces don't line up, an adapter can connect them, but every extra joint adds height and another seal that could leak.

Bong Terminology A to Z

Ash catcher
A small add-on chamber that sits between the bowl and the bong. It catches ash and resin before they reach your main water, which means less cleaning. Pick one that matches your joint size and angle (45° or 90°). Browse ash catchers.
Banger
A quartz bucket used on dab rigs in place of a bowl. It gets heated and then concentrate goes in.
Beaker
A bong with a flared, cone-shaped base, like a lab flask. It holds more water and is hard to knock over. (Hi.)
Borosilicate
The heat-resistant glass most good bongs are made of. It expands only about a third as much as ordinary soda-lime glass when it heats up, so it's much less likely to crack from a sudden temperature change. It still isn't unbreakable. See Borosilicate Glass 101.
Carb cap
A small cap that goes over a banger during a dab. It traps heat and controls airflow, which lets you dab at lower temperatures.
Cashed
A bowl that's been fully burned through and only has ash left. Time to dump it.
Cherry
The glowing ember in a lit bowl. "Pass it while it's still cherried" is good manners.
Clearing
Pulling all the smoke out of the chamber in one go, usually by lifting the slide or opening the carb. Smoke that sits in the chamber goes stale.
Dab rig
A small water pipe built for concentrates, with a banger or nail instead of a bowl. Shop rigs.
Diffuser
Any slits, holes or arms that split smoke into smaller bubbles. Diffused downstems are the most common example.
Glycerin coil
A sealed glass coil or chamber filled with glycerin that you keep in the freezer. Glycerin stays cold for a long time, so it chills the smoke without any ice. It's the idea behind Freeze Pipe pieces. Learn more in What Is a Glycerin Bong? or browse the Freeze Pipe glycerin collection.
Greens
A fresh, unburned bowl. Whoever packed it traditionally gets first hit.
Milky hit
When the chamber fills with smoke so thick it looks like milk. It looks impressive, but you don't have to finish it all at once. Small sips are fine.
Nail
The older word for what a banger does: a heated piece (titanium, quartz or ceramic) that holds concentrate on a rig.
Recycler
A rig or bong that sends water and smoke around in a loop between chambers, which gives smoother hits and a fun water show. See Recycler Bongs Explained.
Resin
The sticky brown buildup that collects in the downstem, bowl and neck. It's your cue to clean the bong.
Rip
One hit from the bong, as in "take a rip."
Screen
A small metal or glass disc that sits in the bowl so ash and bits don't get pulled through. Many glass bowls have built-in holes and don't need one.
Straight tube
A bong whose chamber is one straight cylinder from top to bottom. It holds less water than a beaker, and the smoke clears faster.
Zong
A tube with a bent or kinked neck. People say the kink helps stop splashback, but mostly it just looks good.

Why "Bong," Anyway?

Dictionaries trace the word to the Thai bong or baung, a cylindrical bamboo tube, and date the English water-pipe meaning to the early 1970s. That makes your bong a fancier version of a bamboo tube.

Now Go Find Your Parts

Once you know the vocabulary, shopping is easier. Check the joint size, decide whether you want a perc or a plain downstem, and add an ash catcher if you'd rather clean less often. Not sure where to start? Take the Bong Finder quiz or browse every bong we carry.

Sources