How to Make Cannabutter: Stovetop Recipe + Dosing Math

Cartoon of mrb0ng in a chef hat and apron holding a stick of butter and stirring a saucepan of melted cannabutter on the stove

Here's how to make cannabutter: decarb coarsely ground flower in a 230–240°F oven for about 40 minutes, then simmer it with butter and a little water on low heat for 2–3 hours, strain, and chill. The cooking is easy. The dosing is where people get into trouble, so mrb0ng does the math for you below.

For adults 21+ only, and only where cannabis is legal. Edibles hit differently than smoking: start low, go slow.

Quick facts: Prep 15 min · Decarb 40 min · Simmer 2–3 hours · Chill 2+ hours · Yield about 1 cup · Difficulty: easy

Why you have to decarb first

Raw flower is mostly THCA, which isn't the compound people are after in an edible. Heat knocks a carboxyl group off THCA and turns it into THC. That's decarboxylation, or "decarb." Skip it and your butter will be a lot weaker than you think.

How hot and how long? In a 2016 lab study, researchers heated cannabis extract in a vacuum oven and found THCA had almost all converted after about 30 minutes at 110°C (230°F), around 9 minutes at 130°C and 6 minutes at 145°C. A kitchen oven with whole flower is a lot less precise than a lab oven, so the common home method from Project CBD is 230°F for 40 minutes. Their rule of thumb: expect roughly 80% of the acid form to convert, not 100%.

Ovens lie, by the way. Many run 15–25°F off what the dial says, so an inexpensive oven thermometer is the best upgrade you can make to this recipe.

Ingredients and gear

  • 3.5 g (an eighth) cannabis flower, where legal
  • 1 cup (2 sticks, about 227 g) unsalted butter
  • 1 cup water (it stops the butter from scorching)
  • A grinder set to coarse, or just break it up by hand. A herb grinder keeps it even.
  • Baking sheet and parchment paper
  • Small saucepan, cheesecloth or a fine mesh strainer, and a heat-safe jar or container
  • Oven thermometer (strongly recommended)

How to make cannabutter, step by step

  1. Preheat the oven to 230–240°F and check it with the thermometer.
  2. Grind coarse. Think rice-sized bits, not powder. Fine dust gets through the strainer and makes the butter taste grassy.
  3. Decarb. Spread the flower on a parchment-lined sheet and bake for about 40 minutes, stirring once halfway. It should turn from green to light golden-brown and smell toasty. Let it cool.
  4. Melt. Put the butter and water in a saucepan over low heat until the butter melts.
  5. Simmer low and slow. Stir in the decarbed flower. Keep it at a bare simmer, with small lazy bubbles at most, for 2–3 hours. Stir every 20–30 minutes and add a splash of water if it gets low. Never let it boil hard or fry.
  6. Strain. Set cheesecloth over a jar or bowl and pour the mixture through. Press gently with a spoon. Squeezing hard pushes out more plant flavor.
  7. Chill and separate. Refrigerate for 2+ hours. The butter firms up on top and the water stays underneath. Lift the butter off, pat it dry, and toss the water.
  8. Label it. Write "CANNABIS – THC," the date and your estimated mg per teaspoon on the container right away.

Never leave a pan of melting butter unattended, and keep it on low. Hot butter burns skin fast.

Cannabutter dosing math (do this before you bake)

You can't know the exact strength without a lab test, but you can make a sensible estimate. Project CBD uses this simple formula:

grams of flower × THC% × 1,000 × 0.8 = estimated mg of THC

Worked example

  • 3.5 g of flower labeled 18% THC (total THC)
  • 3.5 × 0.18 = 0.63 g, or 630 mg of THC potential
  • 630 × 0.8 = about 504 mg THC in the whole batch
  • 1 cup of butter = 48 teaspoons, so about 10 mg THC per teaspoon (and about 31 mg per tablespoon)

Treat that as an upper-end estimate. Some THC stays behind in the plant material and some is lost to heat, so your butter is probably a bit weaker, but potency varies a lot from batch to batch and you shouldn't count on it.

Turning it into servings

Most recipes call for more butter than you want infused. Swap in just part of it. Say a brownie recipe uses half a cup of butter and makes 16 squares. Use 2 tablespoons of cannabutter (about 63 mg) plus regular butter for the rest. That works out to roughly 4 mg per brownie, if you mix the batter thoroughly so the butter spreads evenly.

Start low, wait long

  • First time, or new batch? Start with 2.5–5 mg THC. Health Canada suggests 2.5 mg or less to start.
  • Edibles can take 30 minutes to 2 hours to kick in, and up to 4 hours to reach full effect. Wait at least 2 hours before you even think about more.
  • Don't mix with alcohol, and don't drive. Plan to stay put for the evening.

Storage and safety

  • Fridge: keep it in a sealed, labeled container and use within about two weeks.
  • Freezer: portion it into an ice-cube tray, then move the cubes to a labeled freezer bag. Each cube is a known amount, which makes dosing easier.
  • Kids and pets: infused butter looks exactly like regular butter, and edibles look like regular snacks. Store it locked up, labeled, out of reach and out of sight. New Mexico's cannabis regulators suggest a locked cabinet or lockbox. Your raw flower belongs in a sealed jar too. Our storage and stash jars help with smell and keep things organized.
  • If someone eats it by accident: call Poison Control at 1-800-222-1222 (or 911 if it's serious). For pets, call your vet or the ASPCA Animal Poison Control Center at 888-426-4435.

Troubleshooting

  • Tastes like lawn clippings: you ground it too fine or squeezed the cheesecloth too hard. Go coarser next time and press gently. Strong flavors like chocolate, peanut butter or spice cake hide it well.
  • Weak or no effect: the decarb probably ran too cool or too short (check the oven thermometer), or the flower was lower in THC than you thought. Don't "fix" it by eating more in one sitting. Adjust the next batch instead.
  • Way too strong: use less per recipe and cut it with more plain butter. Re-label the container with the lower estimate.
  • Butter burned or smells scorched: the heat was too high or the water cooked off. Keep the heat low and top up the water.
  • Green, cloudy layer at the bottom: that's water and plant bits. Scrape it off the bottom of the solid butter and throw it away.

Cannabutter FAQ

Can I skip the oven decarb since the butter simmers for hours?

Not a good idea. A gentle simmer stays well under oven temperatures, so most of the THCA won't convert. A proper decarb first is what gets you predictable butter.

Can I use coconut oil instead of butter?

Yes. The same method works with coconut oil, olive oil or ghee. Use the same dosing math and label it just as clearly.

How much cannabutter should I eat?

Go by milligrams, not spoonfuls. With the example batch above (about 10 mg per teaspoon), a 2.5–5 mg starting dose is only about ¼ to ½ teaspoon. That's why it's best to bake it into a recipe and cut even portions.

Ready to cook?

Grab a good grinder, label everything, and keep your first serving small. When you're done in the kitchen and want gear that fits your smoking style, take the Bong Finder quiz and mrb0ng will point you at the right piece.

Sources